BOLT SIZE QUESTION

[Dallastar]

think rear seat [pillion] on 98 standard   the single rear chrome bolt that holds seat on [lost mine somewhere, notice it last night gone] what size is that and where do i get it or any suggestions??? thanks

[NITRO]

Look at the parts fiche, it should show on there. I bought one a few years back for my Standard when I lost mine, but can't remember what size it was. You should be able to find the same size at a hardware place.

[Dallastar]

think rear seat [pillion] on 98 standard   the single rear chrome bolt that holds seat on [lost mine somewhere, notice it last night gone] what size is that and where do i get it or any suggestions??? thanks

OK to help out if this question comes up in the future ...I went and replaced all 3 screws and u should know the 2 front are shorter then the one longer screw in the rear

i replaced all 3 with a few threads longer so i could backup with 1 flat 1 lock washer

these are the replacement screw sizes i bought:
the 2 front screws size is  M6-1.0 x 16MM
the 1 rear screw  size is   M6-1.0 x 20MM

the screws are now phillipheads not the hex   works just fine

[Dallastar]

bought screws at Home depot for total $1.85

[NITRO]

bought screws at Home depot for total $1.85

Good! It would have been $2.50 each from HDL.